*Special - HKS Dual Rear Section Sport/Drager Exhaust for your Acura TL



The Super Drager Exhaust Systems from HKS are designed using an unchambered SUS 304 stainless steel muffler assembly. Large diameter mandrel bent aluminized steel piping and an etched Drager exhaust tip are trademarks of a Super Drager exhaust. Using extensive computer controlled flow analysis, dyno testing, and precision fitment design, HKS produces maximum horsepower without dramatically depleting low-end torque. Each HKS exhaust system is flanged and comes with all gaskets and hardware to provide the easiest direct bolt on installation possible. Additionally, HKS exhaust systems utilize factory mounting points and hanger locations. .

All Gone!
Sale Ended

 

Very nice, good price. Too bad I have comptech's (gettho version)

 

dammit!

 

wow those are cool, but i want comptech, any1 want 2 sell thiers?? i am willing to buy them. are the HKS louder than the comptech?? i like the quieter better.

 

Actually my HKSs are quieter than my friends CL equipped comptechs.. I was amazed...

 

The dragers are very cool. They have a low rumble and a soothing deep tone throughout the car at freeway speeds. I've riden inside many Hondas with the "coffee can" type mufflers that give me a headache when going 50+ for only a few minutes. Now with these Dragers though, I actually turn my radio off and relax while listening to soothing sound of these babies!

 

I can assume these will fit the Type-S right? No fitment issue?

 

So is it $430 for the two exhausts?

 

Yes, it will fit a Type S.

Yes, it is two exhausts.

 

ditto to what chaosity said....the hks are sound soothing when crusing on the highway....the sound is deep..it sounds amazing...especially now that i tiook out one of the resonators...it was actualy to quiet for me when i had the resonator in...and they look amzing also

 

these are the axle backs are they?

 

Yes, rear section, axle back

You can do a search for HKS here on the forums, to hear others feedback on them

 

Personally i like the high note of the italian exotics over low note american muscle...think the comptechs satisfy that more? or do the HKS just sound better overall?

 

anybody have any pic of the HKS exhaust on a TL??

 

General question: Do you gain power by adding these types of hi-flow exhausts? If so, how much? Also, what does axle back mean (easier installation?) SOrry for the dumb questions.

 

axle-back simply put is just the end of the exhaust system, the mufflers themselves and the exhaust pipes coming from them...they are cheaper and easier to install, usual just requiring bolt-on installation however as many people have posted, they're mainly for look and sound, and add very little horsepower.

cat-back exhausts include nearly a new exhaust system...it includes the pipes that run under the whole of your car...for the stock TL, cat back would be better because the pipes are not as big as the ones on the type S and would add much more power than axle-backs however they're more expensive and do require more complicated and usually professional installation

 

what would be the price generally of an install

 

Way too much! very easy to do yourself. Just lift the back of the car about 6 inches to give yourself room. I was very inexperienced and it only took me an hour total from opening the new box to sealing that box up with my old mufflers inside it.

 

kool def will consider it

 

hey guys as far as the sound though i dont want it to sound like a cheap civic sounds is it sort of like a CAI when u really dont hear it to to much till u hit the gas hard then it screams......thanx peace

 

also u gotta mod the bumper

 

No modification to the bumper, and as fo sound, it has a low rumble.

You can do a search here for HKS and you will get quite a few results of other members descriptions..

 

ok kool thanx

 

i read something about the tips being too far recessed into the rear bumper and would start heat up the rear. Are extensions necessary or does it bolt right up?

 

The tips are back about 1 inch... but they also hang below the bumper about an inch. I have had no issues with anything heating or melting or deforming. They fit just right.

 

tehy were behind my bumper like 4 inches...was starting to melt my kit....want hard to fix tho...pay to have it extended...its worth it.,..the tips are prefect for our cars...the notches on the oem kit fit almost perfect

 

I think it has to be extended if you have a body kit.

If you do not, I don't believe it's necessary...

 

What happens if you have the WW rear end? If you extend it, will it match up with the notches on the kit?

 

HOW MUCH DOES A GOOD CATBACK COST? WHAT MAKES IT MORE COMPLICATED TO INSTALL?

 

[QUOTE]Originally posted by snook789
[B]*Special - HKS Dual Rear Section Sport/Drager Exhaust for your Acura TL


The Super Drager Exhaust Systems from HKS are designed using an unchambered SUS 304 stainless steel muffler assembly. Large diameter mandrel bent aluminized steel piping and an etched Drager exhaust tip are trademarks of a Super Drager exhaust. Using extensive computer controlled flow analysis, dyno testing, and precision fitment design, HKS produces maximum horsepower without dramatically depleting low-end torque. Each HKS exhaust system is flanged and comes with all gaskets and hardware to provide the easiest direct bolt on installation possible. Additionally, HKS exhaust systems utilize factory mounting points and hanger locations. .


Acura-TL price is $430.00 with free shipping!

Here is instruction on how to place your order.
Follow the link for this discounted price below
username : MVC
password: snookautocar



HOW long do you think this price will last snook???

 

[QUOTE]Originally posted by siMpLe_n_cLEaN
[B]Till what we have on hand is sold
Belive we have 3 left....

 

I just ordered it last week, does that 3 left mean that I got one of em? If you need info, it was to be shipped to Raleigh NC.
Thanks a whole lot snook
Matt

 

Access denied.

For Special prices, you can only pay with Snail Mail, or Check by Fax.


Thank you.

 

Is there any way you can get an under car shot of the exhausts on the car?

 

Do you work with them? If not, re-read the FIRST post.

If you do, the first post should be changed to avoid any confusion.

BTW, my access was not denied.

 

does that mean after these you wont be selling the draggers anymore?

 

are these exhaust's a straight flow design?
if so, will i be losing back-end pressure and will this set off the exhaust sensor?
plese reply asap, i dont want you to run out b4 i order?

btw, is there any way were we can just buy the cat-back exhaust piping that runs back to where it connects to these?

 

Matt - yes, you should of received a confirmation email of your order

FidizzyTypeS - you are not entering in the info correctly, or copying and pasting, as you will not get that message of access denied

njtls - will still be selling them, just not at this price. Purchased all HKS had that they wanted to move before the end of the year

eh!curaplus - design is like stock. This is straight bolt on.
not near sensor, this is an Axle -Back design

As for cat-back pipe, do a search here for Comptech - B pipe

 

snook, the free shipping aplies to everyone right?

even if im in toronto, on M8V-2X3?

as of right now, how many left?

 

hey i was just wondering if you can use the comptech bpipe with these? thanks