I have a 2nd generation TL. I need to know where to run the the speaker wire, power wire, & where is a good grounding point for my DC to DC converter for my deck.
I have a total of 6 speaker wires + din cabels for my zapco stuff, but Im not worried about running them since they wont pick up any noise.

What I mean by "where" is how should they be run so I dont have any noise issues.
Here's a pic of the inside:

 

Well I figured it out..exept the ground for the DC-DC coverter. Ill probably run it directly to the battery.









And heres the spagetti factory

 

DAMN! did you dynamat the whole car?

 

It would have been even better if you had kept the power wire and the audio wires on opposite sides of the car.

BTW that looks really nice.

 

I thought about that, but the way the amps will be in the trunk I needed them split up. I had to drill a hole through that solid steel center beam to route the speaker wires & it was a pain. Thats what I get for wanting a 3 way up front

The floor & rear seat was covered with eDead v1SE then 2 coats of cascade vb1x over everything.

 

Umm man I dont know if you realize this but somebody stole your interior...

 

 

Would it be considered a weird fetish to enjoy looking at pics like this?


I saw your sub setup and it looks tits Do you have pics of your entire system? Are you running the stock HU?