Had my quad tips welded on, check it out
#242
#243
Driver Mod
I have an A-spec TL and bought these but in order to make them fit had to either 1. cut the rear bumper or 2. cut the tips and re weld them so that there was no gap between tips which would cost a lot of dough. I am currently running a Tsudo exhaust.
#244
The following users liked this post:
2Morrow (12-20-2012)
#245
Driver Mod
^^^ You got a pic of them on a TL ? That would be great. With my old ones, they would fit the pipes, but not the rear bumper. In order to do so, the welder would have to position the tip beyond the rear valance of the A-spec kit giving it a very sloppy look. I am looking for a very flush/OEM fitment.
I am a Industrial Designer and I am very particular about my $hit...
Thanks and happy holidayz AZ!!!
I am a Industrial Designer and I am very particular about my $hit...
Thanks and happy holidayz AZ!!!
#246
^^^ You got a pic of them on a TL ? That would be great. With my old ones, they would fit the pipes, but not the rear bumper. In order to do so, the welder would have to position the tip beyond the rear valance of the A-spec kit giving it a very sloppy look. I am looking for a very flush/OEM fitment.
I am a Industrial Designer and I am very particular about my $hit...
Thanks and happy holidayz AZ!!!
I am a Industrial Designer and I am very particular about my $hit...
Thanks and happy holidayz AZ!!!
This is Geeteedan's car. Hope you don't mind me posting your pictures, Dan.
Thread
Thread Starter
Forum
Replies
Last Post
STL TL-S
3G TL Problems & Fixes
9
09-23-2015 08:52 PM
ExcelerateRep
Sponsored Sales & Group Buys
0
09-22-2015 10:39 AM