I just installed Hushmat in my driver's side door, and when removing the door panel I had to pull it over the bump stop screw because it just kept spinning when I tried to unscrew it. Now I cannot figure out how to get the door panel back over the screw so that I can put the bump stop back on.

Any suggestions?

 

pliers....a lot of ppl have this problem

 

^ How does one use the pliers? Needlenose?

 

Use pliers to apply a pulling pressure and then you can unscrew the screw while pulling on the stop. Make sense?

 

Yes, thanks!

 

just order a new one, they have a square base that keeps it from turning
worth it, not to scratch the paint with pliers

 

Pliers worked perfect. Thanks again!

 

I missing one of the rubber bump stops on the front door panel, where can I buy them????

THANKS