03 Acura CL 6SPD Factory Navi / bose system

I installed a pioneer d3 yesterday. We chg inputs to outputs on the harness and bypass the amp but still using the factory wiring for the new speakers. as far as audio everything works. now unable to access climate control on factory navi screen.
the car no longer reads the outside temp and when i activate the a/c by auto button manually the air conditioner just blows regular air it does not get hot or cold when i chg the degrees up or down

please my fellow acuraziners!!!!!!!!!!!!!!!!!!!

 

Make sure nothing got unpluged and your wiring is correct.

I would run new wires for your speakers.

Are the wires your trying to tap into for your speakers going to the amp that your trying to bypass ?

 

if the outside temp guage isnt reading, then something's messed with the wiring to the AC. maybe one of the harnesses got unplugged or something.

 

bypass the amp its not connected any more



i will go back and check to see if any thing is lose or not plugged up



any more ideas???????????????/

 

ask in the audio video part of the forum, you will get a better response there

 

only factory wires I used installing my 2 din was both power wire and ground.
back wires I ran completely new.
Front wires I ran to the mutiboxes on either side of the dash to pick up the factory door wires.
No issues ever.
Start over would be your best response.

 

Go over everything you touched. It shouldnt just stop working out of the blue.

 

x2, but yeah either something got unplugged, or you blew a fuse or something, so again check your wiring

 

problem solved climate control plug was lose