Category: Engine - Power Adders
Price: $125
Private or Vendor Listing: Private Listing
Part Fits (you may select multiples): TL 3G
Location (State/Prov/Terr): CA
Item Condition: Used

Wsup guys, after selling my Slave Cylinder with Check Valve Delete & EGR Delete on here, I've decided to sell my MDX spacer as well.
This spacer is VERY SPECIAL & a CUSTOM product crafted by the famous Paul (NVA-AV6) Who created the EGR delete I sold last week.

Why this spacer?
Well this spacer increases very important torque which the J series lacks with gains from 5-7 torque which is what we crave!
This spacer is from the MDX but milled(cut) down to fit our engines because if it wasn't milled down it wouldn't allow the hood to close down. So this is perfect for any TL 3.2 (base) TL 3.5 (TL-S), or Accord 3.0
You won't have any issues closing the hood with this spacer
Do you homeowork and search around about this spacer and it's gains!

It is used, but this isn't a product that deteriates with use, for example like an amp. It only has a few hundred miles on it and comes with all the studs needed for assembly!

I'm asking $125 shipped FIRM
415 577 2057
I'm located in the Bay Area
I take paypal and am verified and confirmed.








Any questions just PM me
For fastest reply just text me at 415 577 2057
I will update this listing if it gets sold
If you don't want to wait, just paypal me the $125 + 4% to:
ma2hewyu2b@yahoo.com

Thanks guys!

 

how much did he mill it down?

 

Not so sure.
I'll post a link to his thread.

 

http://www..net/forums/7g-performanc...e-results.html


Here's the link for info on the gains in torque

 

^this, and if those are the original bolts, will they be too long to properly torque them since them spacer is thinner than it was originally?

GLWS

 

Matt do u have a ruller or a dial/digital caliper to measure the thickness? If u do can u measure it?! Thanks in advance!

 

wow i hope i can get bump for a great mod

 

its not milled down. its over 1in tall

 

correction** Its 1 in instead of 1.5in so it is milled down.

 

Alright guys, I've confirmed and measured it.
It's 1" thick. meaning..
IT IS MILLED DOWN

All the hardware you see is essential for the install
This is all the proper hardware!

THIS IS READY TO BE SOLD,
I've had about 7 people inquire but no bites yet..

 

SOLD via vladkarnafel

 

Here's the post:

"Ok, we have just about 1.75" of clearence over the intake, of course this does not allow for engine movement. Jacking up a engine so the front mount is on the limiter costs us just shy of 1/2", adding in another gasket and we end up with about 1" that we can raise the intake safely with the hood insulation in place and 1.25" with the hood insulation removed. The stock spacer is 1.574" (40mm) tall, so I can knock off .5" easy enough and can get them from my local source." Posted by Paul (NVA-AV6)