Added a couple Polk 12's, powered by an MTX 2300... it was easier than I thought it would be. The hard part was getting power into the car. I found a grommet (need pictures? I've got 'em), but it was hard to get it through. A little help from a long, thin screwdriver helped, then fed the 8 gauge into the car, and up the driver's side. Removing the seat was a chore. If you need help on that, I've got pictures. Took out the Bose amp and sub, wired the new one up (got pictures of that, too), threw in an old box and powered it up. I'm still tweaking it, but it sounds a LOT better than stock already. I think I'll just get it down to one 12 after I find a good box, or get off my lazy butt and make one. So, anyone out there that is putting it off because they think it is a chore, it's not that bad.

 

Here is the whole process... I hope this link works.
www.imagestation.com/album/?id=4291795659

 

i hope you got 8 ohm subd and wired them parrel to get a 4ohm mono load...
the mtx 2300 is 150x2 4ohm and 700watts bridged 4ohm.
i used to have a 2300 its a bad ass bridged. use it to its full potential


FiddlyD