AEM v2 install problem
#1
AEM v2 install problem
i just finished installing my aem v2 in 2005 acura TL. I didnt know ahead of time that as soon as i pulled the coolant tube all the coolant would rush out. Besides that i connected everything but i was wondering do I take out the old tubes and metal part? Right now it just seems to be hanging in the engine bay.
ALso is there a specific coolant i should get or just any from like target or walmart.
ALso is there a specific coolant i should get or just any from like target or walmart.
#5
Full of water...
i just finished installing my aem v2 in 2005 acura TL. I didnt know ahead of time that as soon as i pulled the coolant tube all the coolant would rush out. Besides that i connected everything but i was wondering do I take out the old tubes and metal part? Right now it just seems to be hanging in the engine bay.
ALso is there a specific coolant i should get or just any from like target or walmart.
ALso is there a specific coolant i should get or just any from like target or walmart.
well that is a closed system, and because of this there is always fluid in the lines, so, yes fluid will come out. i used a pair of small locking pliers to minimize that loss. i cant fully remember, but i believe some of the old stuff does need to come out. i think that "metal part" contains the old tubes as a solid unit, so when you install and or redirect the new lines those old ones come out.
there is a writeup with pictures on how to do this properly. thats what i followed and didnt have an issue. if i can find i will post.
Thread
Thread Starter
Forum
Replies
Last Post
cycdaniel
1G TSX Performance Parts & Modifications
8
12-17-2019 10:58 AM
InFaMouSLink
Car Parts for Sale
7
10-27-2015 06:51 PM
Abe_Froman
Car Parts for Sale
1
09-16-2015 01:27 PM