so i have a 2004 acura tl. i have had this equipment for a long time now..

dls ultimate 12' iridium subwoofer
dls ultimate a7 amp
dls reference 6x9 speakers
and dls ultimates in the front
and avic x920bt head unit.

i know how to install everything but i cant seem to find where to connect the speaker wires to after i install the head unit.

i will be keeping the stock head unit with navi just for navigation and will be putting the aftermarket head unit wehre the radio part ..

so what im getting at is when i put in the amp. i will run rca to amp from new head unit. then run speaker wire from amp to the stock amp will i be connecting to
@ the Stereo Amplifier in the passenger kick panel with the 14 pin gray connector contains the speaker outputs if you want to utilize the factory wiring.

RF+ Blue
RF- Red
LF+ Light Green
LF- Purple
C+ Green w/White
C- Blue w/Yellow
RR+ Red w/Blue
RR- Yellow
LR+ Brown w/White
LR- Red w/Yellow
SW+ Yellow w/Black
SW- Light Green w/Red

Ground -> Black
+12V -> White

or will it be this
@ the Stereo Amplifier in the passenger kick panel in the 20 pin Black & White connector

RF+ Black
RF- Gray
LF+ Green
LF- Blue
C+ Brown
C- Greeen w/White
RR+ Orange
RR- Red
LR+ White
LR- Yellow
SW+ Red w/Blue
SW- White w/Green

Remote Turn-on -> Red w/Yellow
Amp Mute -> Yellow w/Green

please any help is appreciated.

 

sorry if this is a little confusing im just now sure where to run the speaker wires to after i isntall the amp.

 

i really want to install this by today lol as it has been sitting in my room for the past 2 months...

 

I'm not sure what to tell ya here since I don't know what to do when installing a new head unit. If utilizing the factory wires, you'll use the bottom set you have as those are pre-amp and not crossed over already.

 

the top set of speaker wires says to utilize the stock speaker wiring so doe that mean from output from amp to those wires ?

 

https://acurazine.com/forums/showpos...2&postcount=26

 

lol

 

your avatar is painful to see

ouch!