Hey guys I had to remove my front bumper today to install my new headlights and bulbs...

When you do this, to remove the screws/push pins in the wheel well, you have to "pry" the edges of the spoiler out to access the them. It seems like the tape is no longer sticky and I have a gap there now. There also seems to be a lot of dirt/dust underneath the spoiler.

What do you guys normally do about this? Remove the entire lip spoiler, clean everything, replace the double-sided tape with 3M body molding tape and put it back on?

 

I would just leave it. Just tighten the screws on the side from the A Spec spoiler