so there's a pdf file that shows the factory instructions for installing aspec kit rear bumper. it mentions having to cut along the exhaust ports.

anyone know if this is required for the aspec install on a type s??

I tried searching the site and couldn't find the answer. thanks

 

Yes, you'll need to cut the rear bumper to install the aspec rear lip.

Go to estore.honda.com for instructions to install, look for TL rear under spoiler (Type-S)

 

sounds good, I was thrown off because I didn't see any cutting tools on the required tool list. tomorrow it shall be installed.

 

Yup, just take your time and installation should go smoothly.

 

Its not that hard..



Held lip with zip ties due to the bumper being cut


Purchased a gutter guard at home depot and glued it with Liquid nails (Thanks to Gerzand)


Before exhaust install


After exhaust

 

^overkill since OP has Type-S bumper

 

Oh wtf! Lmfaooo i must of missed that on the post

 

Disregard my post!!

 

off topic but it's definitely nice to see you posting around here again!

 

nice work nonetheless, but yeah just did the rear and didn't have any cutting to do. the gray plastic surrounding exhaust tips comes off by hand.

thanks anyways