Just wanted to know if i would still need all those harnesses when doing the 6spd swap with a standalone?

 

wat

 

Ahhh i musta been really out of it when i wrote that.

What i meant was

I'm dropping in a CL-6 engine/tranny.

Now i was wondering if I go with a Standalone will i need to get these harnesses

03 CLs-6 Manual Engine Harness. 32110-PGE-A11
Right side cabin to engine comp harness 32100-S3M-A12
Left side cabin to engine comp harness 32120-S3M-A20

 

damn baller. I'm not sure if you are going to be needing all those harnesses if you are going full standalone.

 

You will need at minimum the ends to wire up. The harness in your car wont plug into all of the motor connections and trans connections.

 

lol JCharged.. no ballin involved just alot of hard work and time figure ill try and get this done before i go and get married lol

fsttyms, so you think i'll need all of them then... i doubt i'll be able to find the ends.. hopefully I can find one in a yard over here I'm not afraid to do some splicing