Q about placement of resistor for LED blinkers
#1
Q about placement of resistor for LED blinkers
I'm getting some LED front signals and I'm about to order some resistors from autolumination. I'm going to place the resistor in the rear inner lining, but I don't know where to place it so it won't burn/melt anything. Where can I screw it into because I don't have power tools to drill out holes.
Q for Josh: Where did you put your resistors after it melted ur inner lining? :P Is there another part to this thread? https://acurazine.com/forums/showthr...00#post9201800
Q for Josh: Where did you put your resistors after it melted ur inner lining? :P Is there another part to this thread? https://acurazine.com/forums/showthr...00#post9201800
#8
Avant Garde Wheels
iTrader: (23)
its jus an ALTERNATIVE to either way.. mine jus splices in the existing wires.. can be taken back off and no damage.. maybe just a melted lining like mine.... lol
to Tequila... i haven't touched it since then cuz it jus hangs there and doesn't seem to touch anything else now..
#9
Lamborghini Aventador FTW
iTrader: (4)
you make mine seem like the wrong way..
its jus an ALTERNATIVE to either way.. mine jus splices in the existing wires.. can be taken back off and no damage.. maybe just a melted lining like mine.... lol
to Tequila... i haven't touched it since then cuz it jus hangs there and doesn't seem to touch anything else now..
its jus an ALTERNATIVE to either way.. mine jus splices in the existing wires.. can be taken back off and no damage.. maybe just a melted lining like mine.... lol
to Tequila... i haven't touched it since then cuz it jus hangs there and doesn't seem to touch anything else now..
Thread
Thread Starter
Forum
Replies
Last Post
Eggs999bacon
2G TSX (2009-2014)
10
09-24-2015 10:08 AM