After dealing w/ my 4x4 MT Navi-TSX for nearly two months...I finally got rid of the wheel gap! I like the outcome very much and thank LannyM and AlterZgo for their suggestions. I installed the following late last week:

Neuspeed Koni Adjustable Shocks (Spring perch set to 5-lowest)
Comptech 110-155
Ingalls rear-camber kit


I am leaving at 3pm to Orlando, so unfortunately I will not be available to immediately respond to your comments.
Enjoy














Front wheel close-up!



Rear wheel close-up!

 

Looks good. Nice shine in ^^^^ pic.

 

so you mean you finally LOWERED your car ?

 

Very nice.

I'll either lower my car or get an OEM kit.

 

How about both? you'll love it much more, trust me.

 

WOW! Very nice!! Clean and sexy! The stock rims look so much better on a clean dropped TSX!

 

That's the ride height it should have off of the show room floor! It looks gooood! I think everyone should lower first and add rims later.

 

tru dat!! i wonder how much of a drop that is...i'm wanting to drop mine but not too low...then slap on the rest of the body kit...

 

The Comptech 110-155 spring was listed as a 1" drop front and rear when it was listed as a TSX application. It's now listed only as a TL application, still 1" drop. They claimed it was not a true 1" drop on the TSX, but I believe it is. Also, caz has the Koni's set .5" down, so it's a good 1.5" drop.

 

the car should come from the factory that way it looks so much better.

 

dang looks good, and may i ask what u use to wax ur car? DAM thats shinny lol

 

it looks so so much better like this. plus im sure it handles better too!

 

How's the ride quality with your setting? Is it close to stock? or a bit harder? thanks

 

Looks good, caz1604.

Now, time for some rims!

 

lol...actually, yes I lowered it but my main goal was to maintain as much factory ride quality while reducing wheel gap. (it really bugged me)

 

LannyM is right! It is probably between 1.5 and 1.75. I have a manual, so AT would be a little lower/

 

Thanks.

I was it with Meguiar's NXT Generation™ Spray Wax

 

Actually, it is very close to stock, if not better at times! It is a tad stiffer, but it handles bumps like stock, but corners way better than stock! My car was at the dealer before I left to Orlando and my service rep raved about how great it drove for a lowered car!

Sorry everyone for that late responses...I just got back from FL about three hours ago!

 

Thanks! Yes, rims are more than likely next!!! I am probably going to get chrome 18' HRE 540R's.

 

CHROME!!!! OH GOD!!!!! Might aswell go to west coast customs and say pimp my ride Yo!

 

You have the same springs as I do, but I'm running OEM shocks. how do you like the Koni's now? Where did you get them from?

 

lol...I don't think chrome looks that bad on a black car! I will check it out though before hand to make sure it looks good, and if it doesn't, I will consider another finish!

 

I love the Koni's...which are the Neuspeed versions that offer two more perch levels. I can't really give you a comparison of oem vs Neuspeed Koni since I never had the Comptech Springs on the OEM shocks, but I love my ride quality and ride height! I purchased them through eBay from asw88 like many others. He doesn't have any listed right now, but he sells them for $574.99 after shipping. GL

 

next 2 mods for me.


Looks good dude