here is just a quick pic of the pioneer 7300 dvd unit and one of the headrest installs we did. you can see the reminants of the cut up factory rear bumper in the back on the left, and of course the aem cai and the dry cell battery.

sorry the pic suks

 

get all that dust away from those screens dammit

 

all right allright... lets get it finished already!!!

j/k... just pay attention to the road ok.... lol

 

you have no idea. its like i sand the rear bumper shave and i have an inch of bondo dust circling the car. i sneeze constantly. and since its winter i have no ventilation because i need to keep the heat in.

 

Its going to look good in your car but i have one quick question i have always wondered about. How do you run the wires from the headrest monitors to the headunit? I know you can just run them under the carpet or dash once you get them to the floor but how do you get them down thru the seat?

 

Thats sweeeeet. I love custom jobs like that. Can't wait to see the final results of the project.

 

tie the wires to a long rod, and shove them down through the seat, then pull them through the bottom.

 

Hey rmstoico, how much would a 96-99 B18 engine run me? Tranny and ecu? Everything for a swap into a civic? Might start a little project civic.

 

i dont sell that stuff anymre, its a waste of time, but when you are ready to buy i will middleman the deal for you for no cost. i will get you the best price.

 

hey how you do that with the headrest!!

if you dont mind insturctions!!

thanks