Wheels, Finally
The following users liked this post:
lsimpson50 (11-27-2021)
The following users liked this post:
jaz_hal (09-22-2020)
The following users liked this post:
jaz_hal (09-22-2020)
#7
I didn't plan on a progress thread, but I guess this is it!
I followed usdmJON (https://acurazine.com/forums/acura-i.../#post15734363) for the LED fogs and STI splitter thank you for the tips.
Thank you.
Offset is 45 and they don't come in polished
Specific angle?
I followed usdmJON (https://acurazine.com/forums/acura-i.../#post15734363) for the LED fogs and STI splitter thank you for the tips.
Offset is 45 and they don't come in polished
Specific angle?
Trending Topics
#11
So it begins
The 4" oval is to make the crossover, no Y's allowed.
It's been a few years since I welded, so a little re-learning curve ahead and I going MIG gasless with Blue Demon 308LFC-O. It's all going to be wrapped so my learning curve won't show. Gotta control the heat because her belly will be skinned.
The 4" oval is to make the crossover, no Y's allowed.
It's been a few years since I welded, so a little re-learning curve ahead and I going MIG gasless with Blue Demon 308LFC-O. It's all going to be wrapped so my learning curve won't show. Gotta control the heat because her belly will be skinned.
The following users liked this post:
rockstar143 (08-21-2018)
The following 3 users liked this post by DaIll1:
The following users liked this post:
DaIll1 (08-22-2018)
#21
Thank you. Need to mount the tips and route the tail pipes. I just wanted to make sure everything lined correctly and see if the picture of the mind's eye was accurate.
Up front I put a Stainless Works 3" (2.5" thru) so in the quiet setting it's the same volume as stock, just deeper (while dumping under body)
Up front I put a Stainless Works 3" (2.5" thru) so in the quiet setting it's the same volume as stock, just deeper (while dumping under body)
The following users liked this post:
DaIll1 (08-22-2018)
#31
The following users liked this post:
DaIll1 (09-17-2018)
The following users liked this post:
DaIll1 (09-17-2018)
#34
Did some interior lighting today. Bought a few of these For the footwells I cut them down to six LEDs each, using velcro to attach under the seat for rear and used full 18 in trunk. Ice Blue BBY
#37
I used a Gesswein BH-60 brushless type rotary handpiece with a high speed burr then sealed gap with clear RTV silicone.
I got this when polishing the wheels and it comes in very handy
https://www.gesswein.com/p-10788-ultramax-mf.aspx
I got this when polishing the wheels and it comes in very handy
https://www.gesswein.com/p-10788-ultramax-mf.aspx
#38