Nats007 K24 JRSC Type S
#1
Burning Brakes
Thread Starter
Nats007 K24 JRSC Type S
PROGRESSION OF MY DC-5... Figured I should have a thread in here if anyone is interested in the DC-5 on AcuraZine.
Cliff Notes: Purchased 2006, supercharged 2012, k24a2 swapped 2014, meth injected 2016. My car was last dyno tuned at 268whp/213wtq at 5psi at 7600rpm in 2015.
As of 2017, I started to learn how to tune after installing a smaller boost pulley and a prototype mercracing inlet. Based on the pulley swap, new inlet, and introduction of water methanol injection, preliminary results are below:
Est. power is 283whp/230wtq at 9psi with no meth. With meth, est. power is 301whp/231wtq at 9psi. Also note, the second half of the graph plots AFR (bold lines) and IGN (dotted lines).
I'm still in the process of tuning, but so far the car feels great! Current bay setup as follows:
Current Mod list
Performance
* Kpro v3
* 2006 K24A2
* JRSC M62 Eaton blower
* MercRacing protoype inlet
* 3.0 inch boost pulley
* K24A2 crank pulley
* Hasport Intake Adapter
* Hondata IMG
* 4130Fab modified K20A2 oil pump
* Fuel Injector Clinic 775cc injectors
* Custom 3" SRI
* AEM Water/Methanol Injection Kit (500cc nozzle)
* GM 3bar map sensor
* OBD I GSR IAT sensor relocated to blower manifold
* OBX RH + 2.5" Flowmaster HP-2 + 2.5" Dynomax Super Turbo Muffler
* Jmercado auto tensioner bracket
* Gatorback 4060817 belt
* Exedy Organic Stage 1 clutch kit w/ 11lb flywheel
* MFactory Helical LSD
* OEM diff bearings
* Hardrace MMs
* Mishimoto radiator, Mishimoto slim fan shroud kit, and Mishimoto fan switch
Aesthetics / Interior
* A-Spec front lip
* A-Spec spoiler
* ITR Sideskirts
* 15% Tint
* Blackout headlights
* Tail Redouts
* CRSX shit knob #23, CRSX adapter, CRSX black suede w/ red stitch boot
* JVC Arsensal KD-A735BT
* Infinity Basslink
* Yellow Depo Fogs
* 4300k HIDs low beam
* Honda EP3 spark plug cover
* OEM Moonroof visor
Wheels/Suspension
* 2004 OEM A-Spec wheels with 235/45r17 BFG Sport Comp 2s
* Mugen Replica front and rear strut bar
* Tein S-Tech lowering springs
* 22mm Progress Rear Sway w/ Tie Bar
* Ingalls Front and Rear polyurethane camber kit
To be installed - sitting in garage
* MTEC Race shift springs
* EPS
My sleeper (current) :shady:
Please feel free to check out the progress pics throughout. Feedback welcomed. I plan on autocrossing in the near future and the drag strip once it's all sorted out
Historical progression:
Jan 2013 - Tuned by magnEsium
Dyno pull:
2014
2012
Older pics:
Hosted on Fotki
Hosted on Fotki
Hosted on Fotki
Hosted on Fotki
Cliff Notes: Purchased 2006, supercharged 2012, k24a2 swapped 2014, meth injected 2016. My car was last dyno tuned at 268whp/213wtq at 5psi at 7600rpm in 2015.
As of 2017, I started to learn how to tune after installing a smaller boost pulley and a prototype mercracing inlet. Based on the pulley swap, new inlet, and introduction of water methanol injection, preliminary results are below:
Est. power is 283whp/230wtq at 9psi with no meth. With meth, est. power is 301whp/231wtq at 9psi. Also note, the second half of the graph plots AFR (bold lines) and IGN (dotted lines).
I'm still in the process of tuning, but so far the car feels great! Current bay setup as follows:
Current Mod list
Performance
* Kpro v3
* 2006 K24A2
* JRSC M62 Eaton blower
* MercRacing protoype inlet
* 3.0 inch boost pulley
* K24A2 crank pulley
* Hasport Intake Adapter
* Hondata IMG
* 4130Fab modified K20A2 oil pump
* Fuel Injector Clinic 775cc injectors
* Custom 3" SRI
* AEM Water/Methanol Injection Kit (500cc nozzle)
* GM 3bar map sensor
* OBD I GSR IAT sensor relocated to blower manifold
* OBX RH + 2.5" Flowmaster HP-2 + 2.5" Dynomax Super Turbo Muffler
* Jmercado auto tensioner bracket
* Gatorback 4060817 belt
* Exedy Organic Stage 1 clutch kit w/ 11lb flywheel
* MFactory Helical LSD
* OEM diff bearings
* Hardrace MMs
* Mishimoto radiator, Mishimoto slim fan shroud kit, and Mishimoto fan switch
Aesthetics / Interior
* A-Spec front lip
* A-Spec spoiler
* ITR Sideskirts
* 15% Tint
* Blackout headlights
* Tail Redouts
* CRSX shit knob #23, CRSX adapter, CRSX black suede w/ red stitch boot
* JVC Arsensal KD-A735BT
* Infinity Basslink
* Yellow Depo Fogs
* 4300k HIDs low beam
* Honda EP3 spark plug cover
* OEM Moonroof visor
Wheels/Suspension
* 2004 OEM A-Spec wheels with 235/45r17 BFG Sport Comp 2s
* Mugen Replica front and rear strut bar
* Tein S-Tech lowering springs
* 22mm Progress Rear Sway w/ Tie Bar
* Ingalls Front and Rear polyurethane camber kit
To be installed - sitting in garage
* MTEC Race shift springs
* EPS
My sleeper (current) :shady:
Please feel free to check out the progress pics throughout. Feedback welcomed. I plan on autocrossing in the near future and the drag strip once it's all sorted out
Historical progression:
Jan 2013 - Tuned by magnEsium
Dyno pull:
2014
2012
Older pics:
Hosted on Fotki
Hosted on Fotki
Hosted on Fotki
Hosted on Fotki
The following users liked this post:
wilspainar (05-03-2017)
#6
Burning Brakes
Thread Starter
Current setup
Current setup with hydro power steering delete using KTuned EP3 adjustable idler pulley and new SRI filter
New filter with VStack
After battling trying to find a belt for weeks, got this Idler pulley and was able to reuse my existing belt.
Comparison of old filter with new. I had to modify my intake arm to accommodate the bigger filter
New filter with VStack
After battling trying to find a belt for weeks, got this Idler pulley and was able to reuse my existing belt.
Comparison of old filter with new. I had to modify my intake arm to accommodate the bigger filter
Trending Topics
The following users liked this post:
knavekid (11-05-2017)
#9
Burning Brakes
Thread Starter
Feb 2018
Finished my tune last month and currently power est follows: 304whp/237wtq @ 8.5psi. will try and get official numbers in the near future.
Update in mods that affected tune: 1000cc vs 500cc nozzle for water/methanol injection, new Blox air filter + VStack, and power steering delete.
Last edited by nats007; 02-26-2018 at 10:00 PM.
The following users liked this post:
knavekid (03-04-2018)
#11
Burning Brakes
Thread Starter
Jan 2023 - resurrection
Back in OCT 2019, I was self tuning and somehow the tune forced the AEM water/meth injection to kick on during starting the car. Motor was hydrolocked.
Car sat for 3 years. Finally had time to rebuild.
AUG 22... off to shop.
DEC 22. New 2008 JDM K24A motor installed with my JRSC. First start in 3 years.
Back home before New Years.
Minor surging issue. Had to physically adjust the TPS as Kpro readings were off.
JAN 23. First car wash in 3+ years.
Car feels great to drive again. I don't miss the lack of power steering, but the whine makes up for it. Still need tires, suspension update, some body work, and repaint.
Car sat for 3 years. Finally had time to rebuild.
AUG 22... off to shop.
DEC 22. New 2008 JDM K24A motor installed with my JRSC. First start in 3 years.
Back home before New Years.
Minor surging issue. Had to physically adjust the TPS as Kpro readings were off.
JAN 23. First car wash in 3+ years.
Car feels great to drive again. I don't miss the lack of power steering, but the whine makes up for it. Still need tires, suspension update, some body work, and repaint.
The following users liked this post:
godfather2 (02-01-2023)