HEY IGGY, can you tell me what wires do I tape into for the LOC?

THanks

 

i taped mine from the sub output since my amp is just powering the subs....

 

Great1,
I'm going to make three assumptions:
1)you've done your home work with the search engine
2)you've seen my posts with schematics
3)you are adding an after market amp to drive your speaks.( and I hope you are replacing the factory speaks)

Allright,
here it is which is also here:
link

Off Head Unit:
left rear - gry/wht + blu/yel
right rear - brn/wht + red/yel
driver door - gry/blk + blu/grn
pax door - brn/blk + red/grn

Notice from the schematic that the front speaker wire colors change somewhere in between the HU and the speaks so if you pull the speakers and see different colored wires you will have to look at the schematic 'cause that's all I'm telling :p . Just kidding, good luck.

Btw, here is where my LOC's ended up:

 

THANKS IGGY