Anybody experience problems being lowered?
09-13-2016 | 07:50 PM
#1
Thread Starter
Intermediate
Joined: May 2015
Posts: 34
Likes: 2
From: Miami,FL
Anybody experience problems being lowered?
Has anybody experienced problems with their axles ? Or anything related mechanically from being lowered ? I got a whole Christmas tree on my dash with "check my transmission", "check VSA" , and "check traction control". Then when I tried accelerating it would rev up to like 5k Rpm and would like crawl slowly. And the D was flashing. Do you know if this covered by the factory ?
09-28-2016 | 06:23 AM
#5
If I remember correctly, there is a sensor that needs to be hooked up that the aftermarket springs do not have.
I want to say; that OP disconnected it when uninstalling and SHOULD have put it back. but i forgot what I'm looking for or describing.
10-01-2016 | 03:19 AM
#6
Summer is Coming
Joined: Jun 2005
Posts: 2,857
Likes: 647
From: Houston
yup, i remember it happening to another AWD member.
If I remember correctly, there is a sensor that needs to be hooked up that the aftermarket springs do not have.
I want to say; that OP disconnected it when uninstalling and SHOULD have put it back. but i forgot what I'm looking for or describing.
If I remember correctly, there is a sensor that needs to be hooked up that the aftermarket springs do not have.
I want to say; that OP disconnected it when uninstalling and SHOULD have put it back. but i forgot what I'm looking for or describing.
Thread
Thread Starter
Forum
Replies
Last Post