Need to tape into a wire in the drivers door and want to run it through the existing grommet but I don't want to break it by prying on it. Anyone have instructions on how to remove it or want to share what you did?

 

Will these two do?

 

Close. I have those. Looking for disconnecting instructions for the wire harness going from the door to the car.

 

Hmm... I don't think I have that in my collection. =( Sorry...

Mind if I ask what your plans are? I think I'm going to follow every thread you start. You seem to give me plenty of ideas. =)

 

haha, putting in an alarm/starter that will disarm and arm the aftermarket alarm by touching the handle on the outside. I have the tech package sh-awd

 

disregard! I pulled back the rubber boot from the outside and I was able to see the connector! Good to go

 

Nice! But doesn't the Tech package have the alarm already? This is very interesting. What other tinkerings have you done?

 

It does, but because of where my car is at times, i wanted a two way remote to let me know if it had been hit/vandalized.

radar detector, alarm/starter (tomorrow night), tint next week, rear glass spoiler...

what are you looking to do?