When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hey guys, i just pressed in my front bushing on the drivers side, I'm reinstalling the lower control arm and was wondering if anyone had any tips on how to get it back in. I've been drinking all day and I'm confused!
Have to make sure that when you took it out you marked where the arrows were pointing on that compliance bushing. Make sure you press the bushing in at level and make sure it's even on both side and tight. Only clean the housing with a bit of sand paper if it's really rusty. Press it in after. Make sure you do it properly or it's no good.
04-16-2016, 08:44 PM
