cprime

I was lucky enough to find both Type-S front and rear A-Spec lips used, but unfortunately didn't come with all the hardware.

Found some of the stuff I'll need, but was wondering if anyone ever did a DIY on fabricating the brackets for the wheel wells that attach to the bumpers. Since the OEM hardware kit has been discontinued for years, I'm surprised that I can't seem to find anything on this.

Doesn't look too hard to do, but it would certainly help if someone who actually did it before could guide us in creating our own.

sxgay

That's a lot of work. I just used the tape, and then used the bolts where the plastic tabs and screw on each side by the rear fender Wells

cprime

I get that it will be some work, but I would like to make them if possible.