I know this i asked a lot but does anyone know if these tips will fit into a base bumper?
https://www.ebay.com/itm/261604376907

 

Measure width of otips

Compare to opening of base TL bumper

if opening > width of tips = fits
else = no fit

 

*edited*

I found a thread where people were putting tips on a stock bumper, and the claim is that the cutouts are 6.5 inches...https://acurazine.com/forums/third-g...-849764/page2/

So assuming that this ebay vendor's measurements are exactly on spec, then it will be a very tight fit. I would worry about melting your plastic.

 

Here's the SoCal 3'' Quad Tips on my base:

 

Thanks for the replies, I wanted some staggered ones but if the socal are the main ones that only fit than i might just go with those

 

Yeah will not fit at all I already tried on my old TL. Ended up getting the Type S rear lip so they can fit
and it was still a tight fit.

 

BULLSEYE, which ones are you referring to when you said they will not fit? I assume the ebay ones that OP posted

 

Yeah the ebay one

 

Finally someone posted a lipless base with quads. Thank you, Mr. Showtime. I was thinking about doing the same, but I'm gonna hold out for a rear lip.

 

It's funny because I was eyeing that exact same quad tip lol. I didn't buy because i was unsure of my current/future exhaust setup. Good to know it doesn't fit.

 

No problem. A few months later I put on a full aspec kit and the SoCal quads still fit without issues.

 

Almost any decent shop can remove the factory exhaust bezel and trim the clearance for the tips. Finished with 1/8th self gripping U-channel and it looks sweet. I'm going to trim mine to fit type S mufflers.

 

Looks good, but would've looked better if they sat little higher.