06’ HID Ballast Pos/Neg Terminals
#1
Great Northerner
Thread Starter
06’ HID Ballast Pos/Neg Terminals
The pictures below are for illustration purposes only but they get the point across (I hope) of what I’m asking.
I’m going to tune a new set of projectors and I need to supply power to the ballast. Unfortunately I don’t have a harness to connect to the black connector on the ballast.
Does anyone know which prong is the positive and which is negative on this male connector? Until I find a harness, or if someone knows how to make a connector, I’ll just have to be VERY careful.
I want to tune the projectors without taking my front bumper off. Anyone done anything like this? Thank you!
I’m going to tune a new set of projectors and I need to supply power to the ballast. Unfortunately I don’t have a harness to connect to the black connector on the ballast.
Does anyone know which prong is the positive and which is negative on this male connector? Until I find a harness, or if someone knows how to make a connector, I’ll just have to be VERY careful.
I want to tune the projectors without taking my front bumper off. Anyone done anything like this? Thank you!
#2
Senior Moderator
Take a multimeter to the pigtail in the car to test pos/neg and then compare that to the input on the ballast.
Or just buy these https://www.theretrofitsource.com/ma...-pigtails.html
Or just buy these https://www.theretrofitsource.com/ma...-pigtails.html
#3
Race Director
iTrader: (8)
Referring to your 1st image, the right prong is ground and the left is positive.
Thread
Thread Starter
Forum
Replies
Last Post
Spence52490
3G TL Audio, Bluetooth, Electronics & Navigation
20
08-02-2013 07:23 AM
Bruce Banner
3G TL Audio, Bluetooth, Electronics & Navigation
2
04-07-2013 12:29 AM