2000 TL....Hey guy's need some help here!!! I'm trying to change all my wheel stud on the Left front end got one out..but when i tried to put the new one in that's when the problem start somehow it will not go in there is a resistance, the tip of the stud is rubbing the hole i tried to hammered it in and it's so tight it end up scrapping the stud...I use the DIY and looking on the posted Pix it's seem a flawless job..Somehow i can't get it done right any help would be greatly appreciated thanks.

 

Is it the right size? 12x1.5

 

 

Thanks for the video Nick yest it's the right size.I Just finished the job it took me a while though because I change all 5 of them and pretty much the same way on the video shaved a little bit the side of the studs. Thanks again Nick.....