OK, I need some help here. I finally got around to installing my Philips 6000K D2R bulbs today. I was so excited to go out tonight and check them out. Well, they look really sweet from outside, but when I started driving I noticed that I couldn't see a damn thing! :banghead: I know I put everything back in properly. Is there a certain way to put these bulbs in that I could have screwed up? They seem like they are aimed really high, but I can't figure out why. Please help guys, I'm blinding oncoming traffic and I can't see where I'm going! Thanks in advance for your help.

 

u must have been screwed on the clip that secured the bulbs. yeah, it's a bit tricky. check out if u can still move the bulbs up & down. if so, it's not secured. once it get it done, u will be fine.

 

Thanks for the advice. Anyone else know if the bulbs have to go in a certain way? I wasn't sure if they can go in any way, or if the little post had to be on top or bottom? Thanks guys.

 

When I installed them I remember popping in the passenger side in 3 mins. The driver side too me 20 mins. Then I saw that it did matter cause there of the metal clip. When I figured that out it was installed but they were both aimed wrong. One was a little higher than the other and one is a little brighter than the other. Did I do anything wrong ?