Finally got it in, it is an OEM one too.

Gonna sand her down today and repaint it. Anybody know the bolt/screw sizes for the 4 side holes? I was gonna completely zip-tie her up but wanted to atleast have 2 screws in..
Thanks!

 

it should have came with OEM hardware if OEM.

 

Once you take the regular lower front extender off the bumper, you may be able to reuse some of the connectors ?

 

Yes just use what's in there now. Order new push pins if you want.

 

02-03 are different from 99-01

you need the hardware that comes with the front lip

 

here.. use these pdf I attached

 

sanded her all around with some 400.. smoothed her out then put on 2 coats of black and 2 of clear.
now just to go lower in the front!

 

Looks real nice, where did you find an OEM one?? I damaged my front lip and I have no clue where to find the oem one

 

Found my on Ebay. Someone in the BM has one for 100$

 

Did u spray it just regular black??? You should have color matched it.
Don't go lower in the front unless you lower the rears alongside, because ur car looks pretty even from the dumb angle picture.

 

Looking good !
Black is usually an easy match, unless metallic.
Go lower, hmmmm.....may scuff up that new lip ! But, that's how the big boys roll.

 

The only black stock color that came out for the 2g was NBP Nighthawk Black Pearl, which is not just black. You would need to spray a pearl coating as well.

 

damn wish my paint was easy to match like that!!

damn you naples gold metallic!!