Carbon Fiber
#44
Senior Moderator
iTrader: (2)
Join Date: May 2000
Location: where the weather suits my clothes
Age: 55
Posts: 27,921
Received 1,080 Likes
on
661 Posts
Just to provide some more information, this is NOT a do-it-yourself job. You can read up on how to remove the door pieces, which itself is a major hassle.
Tim's CF trim is actually dipped to create the CF look. You can look on the web for services that do that, but it is quite expensive. If you try to go the Avery vinyl route, be warned, it is extremely difficult to get it to look good. I bought an entire roll of Satin Silver film and pretty much wasted half the roll before I gave up and had them painted Satin Silver. The problem is making the curves. The door pieces might not be too tough, but the center console pieces are a b!tch.
Tim's CF trim is actually dipped to create the CF look. You can look on the web for services that do that, but it is quite expensive. If you try to go the Avery vinyl route, be warned, it is extremely difficult to get it to look good. I bought an entire roll of Satin Silver film and pretty much wasted half the roll before I gave up and had them painted Satin Silver. The problem is making the curves. The door pieces might not be too tough, but the center console pieces are a b!tch.
Thread
Thread Starter
Forum
Replies
Last Post
08_UA7_Gr33k
Member Cars for Sale
13
02-11-2016 02:17 PM
LogicWavelength
3G TL Photograph Gallery
33
11-01-2015 09:38 AM