Those of you who know about the RES will it fit if we have the SC?

 

Yes it will. I believe both Doug and Comptech confirmed it.

 

I think, the answer would be yes. I am NOT liable for the tranny failure...

Anyways, where is the fooken RES....:angry:

From now on, It is called RESmyASS

 

Also the crank pulley from unorthodox, will it effect the SC, did CT ever say that they were going with a twin screw SC or not?

 

Because if it is a pulley based SC then a lighter crank pulley will increase boost also, maybe making 90 hp instead of 75hp....hmmm....... I like

 

[

From now on, It is called RESmyASS [/B][/QUOTE]

Maybe now your ass will get some consideration

 

: :

 

From what I understand, there is nor dual benefit. The RES would basically become worthless when under boost. The resonance effect would be irrelevant when the whole manifold system already at a higher pressure negating the differential and filling effects.

I could be wrong but by the very nature the RES is supposed to work, increasing the manifold pressure would drop the resonance effect out.

 

The Unorthodox crank pulley will be a larger diameter and lighter. Being lighter is always helpful but when it is larger ( to reduce parasitic drag) the blower would also be affected reducing it's boost output.

Now this could be corrected by putting on a smaller SC pulley.

 

You guys are assuming either of these items actually do come out...

 

Comptech SC is confirmed....it is an m62 Eaton blower...now the RES is a whole other story.

 

I think the RES will come out. If not from Doug, then somebody else. If doug can't make the fabrication work out, he'd be stupid not to sell the design and make a good buck.