http://home.satx.rr.com/silverbullet/hks/

I just installed it, and its not loud at all, but perfect! Looks nice too. I stopped by the Honda dealership and picked up some rubber mounts. 3.89 each for a v6 ex accord. Fit perfect. That was to fix the left side up higher. I will have a detail write up by this weekend for you guys on how to install them.

Also did the free/coldair intake mod with 3 inch dryer duck. Thanks JROCK! I defintely feel a seat in the pants more power improvement from this. The car defintely likes chriping 2nd all the time now.

 

Thats one bad CL aright!

 

Good choice in exhaust

 

Welcome to the club!!!

 

Ar there any gains w/ the hks exhausts (dyno proven)..or do they lose torque at midrange like some other exhausts? thanks and good luck w/the car

 

I couldn't really tell you, but with the intake mod I did, I defintely felt an improvement.

 

You shouldn't lose torque with just a change of mufflers which is all an axle-back system really is, especially if they're barely much louder than stock.

If you do cat back and remove the pre-muffler and all that and improve the flow AND use hi-flow mufflers, sure you will lose some torque and gain some hp.

With comptech and HKS super dragers I'd wager you gain like 3-5hp at the most and MAYBE lose 1-2 torque if any.

 

What free/cold air mod are talking about? removing the resonator?

Eh nevermind, just saw it in your pics.....

 

That and adding the dryer ducking to flow in colder air.

 

Exausts look good, welcome to the club..........

 

What does the duct connect to on the other side?

how does it stay in place on the other end?

 

The other end is curved towards the fog light, and held in that position with 2 large tie straps.

 

looks good man

i just got mine installed too pics here
http://www.acura-cl.com/forums/showt...threadid=81433

 

Yours looks sweet man! I love it!

 

ah i see..Also, very nice installation, looks great

 

Nice install and pics. They may look a tad big, but overall they definately look sweet.