OK I have a quick question...I took off my front bumper so that I could measure the lower grille and do other grille related stuff. I reinstalled the bumper, but it seems to be sitting lower then I remember it. So I took it back off and tried to reposition it, and I noticed that the brackets that are below the lights where the bumper tabs slide into seemed to be loose. So I pushed it up closer to the lights and tightened it down. I reinstalled the bumper and it is still sitting to low. Any ideas on what could be wrong? I have taken the bumper off like 4 times and I still cannot find the issue...what am I missing.

Thanks for all your help...
Art

 

Bump...

 

pics of the problem would help tremendously

 

I have this problem as well...I believe it depends on how high/low you adjust those brackets.

 

The sides of the bumper look good the only issue is the center point of the bumper. The gap between the hood and the bumper (where the two hood points meet up with the bumper) is about 1/2 inch. I will try to post pics of what I am talking about!