Attn: Scalbert And/or Smitty And All Others W/ Mugen T-stat
#42
Safety Car
Join Date: Jun 2002
Location: Honolulu, Hawaii
Age: 48
Posts: 3,992
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by fuzzy02CLS
I see now. Where was I when this was discussed? Since it's hot in FL almost all year this may be good for me. Does all this just swap right in, or is there some wiring/moding involved?
I see now. Where was I when this was discussed? Since it's hot in FL almost all year this may be good for me. Does all this just swap right in, or is there some wiring/moding involved?
where was I during all this?
probably in ramblings
![Big Grin](https://acurazine.com/forums/images/smilies/biggrin.gif)
#44
Senior Moderator
iTrader: (2)
Ok I put my stuff on Thanksgiving morning. Took about 1.5 hours. It wasn't very hard, but It was a pain for me. I though it would be easier to take the fan switch off after I took the theromstat housing out, but the damn thing wouldn't come off. So I put it back in, took my open end wrench & it broke loose. Then had to take out the housing again. Next, I had a bitch of a time getting the stock thermostat out. It was stuck in there very good. Next I tried to fit the Mugen stat in, & the gasket was too big, I couldn't get the housing back on. So I just used the one off the stock T-stat. Is that ok to do?? I hope it was the correct t-stat. It had the same part # as posted. It fit fine. I used a bottle of water wetter as well, & added some more water to the system since I lost a bit of coolant in this process.
#50
Three Wheelin'
Join Date: Feb 2003
Location: Grand Rapids, Michigan
Posts: 1,796
Likes: 0
Received 0 Likes
on
0 Posts
All done here also. It does seem as if the temp gauge is a notch lower. The heat gets plenty hot now at 40* outside. We'll see around Jan/Feb how well it heats up. I hate antifreeze,.... slimey crap. :shakehd:
#54
Suzuka Master
Join Date: Sep 2000
Location: Woodstock, GA
Age: 54
Posts: 9,431
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Chemmech
What's the purpose of coolant lines in the throttle body anyhow?
What's the purpose of coolant lines in the throttle body anyhow?
#55
Three Wheelin'
Join Date: Feb 2003
Location: Grand Rapids, Michigan
Posts: 1,796
Likes: 0
Received 0 Likes
on
0 Posts
This mod might keep the trans cooler also. Engine coolant is used to warm up the trans fluid,....although it may head to the trans cooler after that. Hmm,...
Thread
Thread Starter
Forum
Replies
Last Post
DerrickW
3G TL Performance Parts & Modifications
9
11-15-2015 05:52 PM