studville

I had one of my fog lights on my 06 TSX shatter. (no clue how the bulb burst and the lens and everything is still intact)

I know how to change the bulbs (I actually wrote a DIY a while back), however, from what I remember removing the entire housing is a different animal.

Mainly, I want to remove the tiny glass pieces rattling around in there. Short from finding a small vacuum and sucking them out, what type of job will removing the housing to empty it out entail? -- or any other ideas are welcome.

I wonder if I blow some compressed air in there it will clean it out...

MMsTSX

how about a coat hanger.
with some tape on the end of it, with the
sticky side of the tape on the outside?
masking tape is what I would use.
just a thought.