rza49311

iTrader: (1)

A friend and I installed my tein ss coilovers over this weekend along with a comptech rear sway bar and the M3 lip. Just need to get an alignment and have the ingalls kit installed. We tried to install the ingalls rear camber kit but after installing it and taking the car for a test drive, it was like you were driving a boat the toe and camber were so outta whack i'm guessing. I still plan on getting some tint as well.

Before...





During install...




After..

Milton TSX

very nice, I like the TL rims

Newplay1

That looks decent, now you will get more of "I luv that TL comments from people"...

minkl81

iTrader: (2)

nice drop
did you scrape any going over the bumps yet?

xizor

very nice drop! the key for the ingalls kit is to match the length to the stock bars as much as possible and then drive yourself asap to an alignment shop to get it properly aligned

jlukja

Looks sharp.

JTso

iTrader: (2)

When I perform the Ingalls kit installation, I install the rod ends onto the shaft with the exact amount of exposed thread on each side, then use the mounting bolts for alignment. I'd place the partially adjusted ingalls link over the stock link on a workbench and turn the center of the shaft (without moving the rod ends) until the mounting bolts drop through the stock link mounting holes below. This will give you the closest match to the stock links.

minkl81

iTrader: (2)

everyone in here is getting ingalls with its adjustability. i feel bad getting the spc

rza49311

iTrader: (1)

I have not scraped anything nor do the tires rub..so far

We tried to follow the install instructions that many have given on the board for the ingalls kit but after putting the car on the ground, it was so visibily off, we abandoned it for now.

waTSX

Looks great dude!

Black_6spd

<---wishes So. Calif. had front lawns the same size...

CJams

Nice TL.........Love the drop and rims

ShortyeuroR

nice ride!! i should have installed a lip spoiler instead of the factory spoiler.

rza49311

iTrader: (1)

if I put the rear camber kit back on then take the car to get it aligned, do they need to know a certain camber setting? I mean is there a factory camber setting or do they know what it should be?

xizor

there's a factory spec they can look up and make sure you car is aligned to meet