do you need the stock airbox to run the icebox, what all do you need? i have cold air but im thinking about swapping for this.

 

The icebox comes with its own airbox. I actually just got mine today and look forward to getting it installed on monday by heeltoe along with other goodies.

When you order the icebox, it comes with the airbox and everything else you need. You use the old air tube that connects to the engine i believe.

if any of my info was wrong, please correct me members, just trying to help out.

 

You need the bottom half of your stock airbox, and the original plastic piping!

 

knew i shouldnt of thrown it out. ill have to find some stock pieces.. thanks for the replys

 

hint for the future (personal lesson learned), whenever doing a mod, NEVER throw the parts out. I tossed my OEM header and cat..... 2 months later, someone wanted to buy them. I only tossed them do make room for a move and it was a hit in the wallet after I tossed them.

 

X1000000000000!

I wouldn't even sell them though! If you ever need to put that stock cat back on you're screwed!

Marcus

 

Good point!! I should've mentioned that as well. For me, I'm going to either run this TSX into the ground or sell it to a kid who wants to have some fun. My TSX isn't a +30 yr old's daily driver. It's tough in traffic (per the mod list below) and it there's lots of little add-on modules from Kptechnologies, so most folks, who don't know me, are going to think twice about my TSX due to all the modes. The good news is they all work great, just not a car I would look at if I wanted a totally/OEM clean TSX.

 

what plastic piping are you talking about the one that connects to the bottom of the stock airbox?

 

There's the nipple that goes from the fender well to the lower box, and you reuse the tube from the upper box to the throttle body.

Marcus

 

Nope, the plastic piping between the throttle body and airbox.