got a knock sensor code any thoughts? P0325 seems to have picked up a harmonic in the lower rev range as well. cant hear it can only feel it. might be time for that spare motor I saw on ebay...

 

is it too lean?? or over timed??

 

the book says its either a dead sensor or a short it the wire. or a smoked ecu... I ordered a sensor ill check the wire tomorrow at lunch time. really hope its nothing major... so not the time for this...

 

hopefully its just the sensor doubt it could be a fried wire

 

as far as over timing it I never touched the timing on my last trip to the dyno. all I did was add a little boost to the top end and set fuel to 11.91 then just started backing off the knock sensitivity till I was happy with the curve I was seeing on the screen. I only allowed the motor to run to the potential that was there. didn't go for broke. maybe I pushed out a head gasket or hurt it on the street screwing around. or maybe its just a sensor.

 

does any one know where the hell the stupid thing is anyway???

 

reset it and now its fine....?.... WTF.... stupid sensor....

 

not a 100% where the sensor is i think its on the back of the engine.. ill have to look at the shop manual to confirm

 

pretty sure its under the intake manifold.?

 

its under the intake manifold on the front of the block next to the starter.
and I replaced the sensor no further issues.