When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
So I made a setup with a 3 jaw puller to wind back the PP to where it need to be but why when the tab is are far as it goes there's still is a 1/8" gap where the pressure plate meets the flywheel.
I know nothing about the sac pressure plate.
Should i just screw it down now or is there something else I need to do ?
10-02-2014, 05:18 PM
