Carbon/matte wrap rear
#1
Carbon/matte wrap rear
Hey guys, i need your help here, i wanna wrap the plastic around the liscence plate! Carbon like or matte black but without hiding the back up lights! How do you do it ? I didnt find any DIY and i looked for it really!
Thx for your help
Sorry for my bad english hehe
Thx for your help
Sorry for my bad english hehe
#5
3m carbon fiber vinyl. lay the vinyl over the section, heat it so it holds into the grooves then cut the excess vinyl with a exacto knife. Just google vinyl wrap application and observe the techniques used.
The following users liked this post:
Enrick Gatien (04-17-2016)
Trending Topics
#8
I did mine recently and I took out the entire plate holder assembly and unscrewed the silver trim piece to make wrapping it easier. There's 4 8mm (i think) nuts holding the tag assembly in, and some clips, and then 3 screws holding the silver trim on. Not difficult to remove, and makes wrapping it a much easier affair.
I used VVinyl wrap in black brushed steel. It looks pretty good, but after using this and 3M vinyl, 3M is MUCH easier to work with.
I used VVinyl wrap in black brushed steel. It looks pretty good, but after using this and 3M vinyl, 3M is MUCH easier to work with.
Thread
Thread Starter
Forum
Replies
Last Post
DwDrummer
5G TLX Audio, Bluetooth, Electronics & Navigation
5
01-15-2016 08:43 PM