I've used this amp for a few months, It was new when I installed it, Its a great sounding amp with loads of power and its clean power, The bottom end is smoother than my current Zapco's. Great amp with lots of control and choices with going active using component drivers.

I'll take 150.00 shipped for this super clean amp,

No original box, but I do have a printed manual. I purchased this new several years ago and have only recently used it.

bridged 2 channel 200watts 4 ohms

4 channel 4 ohms 75 w
4 channel 2 ohms 100w

 

ttt

 

• 4-channel car amplifier
• 75 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms)
• 200 watts RMS x 2 in bridged mode (4-ohm stable in bridged mode)
• 2-, 3-, or 4-channel output
• variable high- and low-pass filters (50-5,000 Hz at 12 or 24 dB/octave)
• subsonic filter (15 Hz @ 24 db per octave)
• Maximum Dynamic Headroom (MDH) power supply
• Tri-way capable (Tri-Way crossover required)
• 6-Way Smart System Protection (SSP) circuitry
• high-density split-dome convection heat sink for extreme heat dissipation
• Pre-EQ switch adapts amplifier for biamping Polk/MOMO component speakers
• RCA inputs accept both speaker- and preamp-level input (To use the inputs as speaker-level, you must attach RCA connectors to your speaker wire.)
• preamp outputs
• fuse rating: 30A x 2
• 8-gauge power and ground leads recommended — wiring and hardware not included with amplifier
• 15-15/16"W x 2-9/16"H x 9-3/4"D
• warranty: 2 years

awesome amp gets the job done

 

Sold