mr tl

Category: Audio/Video/Electronics
Price: $75
Private or Vendor Listing: Private Listing
Location (State/Prov/Terr): Can-ON
Item Condition: Used

Very good condition, works perfectly. Includes manuals and all hardware/connectors.


2/1 Channel Operation
Adjustable Crossover (LP)
Auto Overcurrent Protection
Bass EQ Circuit
Bass Engine Ready
DC Straight Design
DC-DC PWM Power Supply
Discrete Pre-Amp Stage
Gold Plated RCA Input Connectors
Input Mode Selector Switch
MOSFET Final Outputs
MOSFET Power Supply
MultiMode
Noise Elimination Coil
One side Terminal Layout
Phase Selector
STAR Circuitry
Solid Copper Bus Bars
Speaker Level Inputs
Subsonic Filter
Specifications:
Dividing Network : 50Hz-200Hz HP/LP (12dB/oct)
Foot Print (WxHxD)in : 7-1/8O x 11O x 2-3/8O
Foot Print (WxHxD)mm : 180mm x 280mm x 60mm
Frequency Reponse : 10Hz - 50kHz (+0, - 1dB)
Heat Sink (WxHxD)in : 7-1/8O x 10-1/4O x 2-3/8O
Heat Sink (WxHxD)mm : 180mm x 260mm x 60mm
Input Impedance : 10k ohm
Input Sensitivity (for rated power) : 200mV ~ 4.0V
Power Requirements : 14.4V DC (11V to 16V)
Signal to Noise (S/N) : 100dBA (referenced to rated power)
Slew Factor : greater than 5
Speaker Impedance : 4 or 2 ohms(stereo), 4 ohms(bridged)
MAX Power (at 14.4V,EIAJ)
Bridged 4 ohms : 400W x 1
Per channel into 4 ohms : 140W x 2

RMS Power (at 12V,20Hz-20kHz)
Bridged 4 ohms : 150W x 1 (0.3% THD)
Per channel into 2 ohms : 75W x 2 (0.3% THD)
Per channel into 4 ohms : 40W x 2 (0.08% THD)
RMS Power (at 14.4V,20Hz-20kHz)
Bridged 4 ohms : 200W x 1 (0.3% THD)
Per channel into 2 ohms : 100W x 2 (0.3% THD)
Per channel into 4 ohms : 60W x 2 (0.08% THD)

porkyxp

interested. did you use this in your tl? I've got a set of components I'm thinning about putting it in there and using this amp for the for them, leaving center and rear on stock ... any input?

mr tl

Yes, had this in my tl for the same setup you want to do. Left the rears stock, and this was powering my fronts. Was very happy with the setup.