OK, I set up my install for Saturday (I was going to do it myself ... but ... anyway) and as my luck would have it, my ... scratch that OUR advisor El runs of to Vegas ... I shot him an e-mail but he was already gone ... he has advised me every step of the way on my upgrade and has been a most valuable asset ... BTW I had my not an ashtray bin modified by Street Effectz to hold my XM Commander ... quality job ... looks factory ... ok back to the story here is what I am having installed:

Alpine MRV-F540 Amp (4 channel)
MBQ 269's (6x9's)
A/D/S/ 345CS (Components - 5 1/4 with spacers made to El's instructions)
XM Commander - via blitzsafe and line driver (Antenna to be installed on rear deck)
Cascade Audio ZMAX / ZB2 (front doors)

I printed out the preamp output instructions (with the correction to read B11) and will give it to the installer (they were talking about using LOC's until I showed them the printout from El ...) ... is there anything else I should discuss with the installer?


Andy

 

Aw, man : ( How'd it go?