Stock Intake Manifold Port/Polish
#1
Stock Intake Manifold Port/Polish
Ordered a stock manifold so that I could work on a P/P for this without spending too much for a P2R one and getting better results while leaving my existing one on the car. So far the runners are gasket matched and honed. Still have polishing to do. Next is the inside plenum, just waiting on some flap wheels and extensions, I've already honed the manifold opening and parts of the inside with a 2-3/4" Flex Hone. Manifold has also been powdercoated flat black. More updates by early next week. Should get this on the car by next weekend along with the bored TB.
gasket matching
grinding
hone work
gasket matching
grinding
hone work
#3
little more work done yesterday. Worked on mostly cleaning up some of the areas where the first runners are. Giving the air an easier path to take. Grinded down a few of the ports that were intruding into the manifold. Still a couple more hours before I call this a finished product but it's getting there. Also threw in a photo of the powder coating
The following users liked this post:
NBPDC505 (08-30-2023)
Thread
Thread Starter
Forum
Replies
Last Post
Total2f
Car Parts for Sale
17
06-02-2012 11:51 AM