Hi all. I'm hoping someone might have hit this already and give some advise.

I've got everything apart to pull the passenger side axle out. I've already done the driver side, getting in to pop the side out of the tranny is a PIA. However I CANNOT get the passenger side to separate from the intermediate axle.

I've looked at the new axle and there isn't any locking device. I've spun it around while prying on it and getting no where. I'm very cautious of using a hammer on anything. Also it's impossible to get direct contact.

Any advice before I use a chisel to get at it?

Scot

Thanks in advance.