i have a Pac Audio SNI-15 and im trying to tap to the rear subwoofer line i use to have it hook up by a professional but i took it out,anyways so im trying to rewired it again.so the color for the converter is


white
white/black
grey
grew/black
brown
light brown

which color wires do i use?

 

Are the /black wires the positive or the negative for that unit?

 

I posted in some thread with the color codes for the TL's audio system. I, well..not me (previous owner) tapped into it at the factory amp so my LOC is tucked away in the kick panel. Fits beautifully. Let me see if I can find that thread....


OP- saw your PM ...sorry I'm just now getting back to you.

 

This thread should be helpful....though I'm using the SNI-35

https://acurazine.com/forums/3g-tl-audio-bluetooth-electronics-navigation-94/loc-questions-799938/


-----------------------------------------------------------------------------------------------------------------------------------------------


This gives the speaker wire colors to and from the factory amp

Quote:
Originally Posted by spyfish007
You ask and you shall receive ....

@ the Stereo Amplifier in the passenger kick panel in the 20 pin Black & White connector

RF+ Black
RF- Gray
LF+ Green
LF- Blue
C+ Brown
C- Greeen w/White
RR+ Orange
RR- Red
LR+ White
LR- Yellow
SW+ Red w/Blue
SW- White w/Green

Remote Turn-on -> Red w/Yellow
Amp Mute -> Yellow w/Green

Quote:
Originally Posted by spyfish007
In addition ....

@ the Stereo Amplifier in the passenger kick panel with the 14 pin gray connector contains the speaker outputs if you want to utilize the factory wiring.

RF+ Blue
RF- Red
LF+ Light Green
LF- Purple
C+ Green w/White
C- Blue w/Yellow
RR+ Red w/Blue
RR- Yellow
LR+ Brown w/White
LR- Red w/Yellow
SW+ Yellow w/Black
SW- Light Green w/Red

Ground -> Black
+12V -> White

 

Here's for the SNI-15:

White: Left(+) speaker
White/Black: Left(-) speaker
Grey: Right(+) speaker
Grey/Black: Right(-) speaker


JDA- black markings are (-) wires

 

thanks for the help trunk monkey yeah i was confused about the two sets of line i just pair the + and - wires from the loc together

 

Yup. Pair the LOC pos and pair the negs, then match it up with the sub channel and your golden! Good luck