I travel to Canada on occasions. My Navigation system has maps, routes and locations in the Windsor and Toronto areas. I can not program a destination to Canada , but when I am in Canada , I can program a destination back to the states and have it route me. Is there a way I can program a destination to Canada?

 

This is a good question as I maybe traveling to canada soon myself...

 

I didn't have any problems programming destinations in Quebec and in the Ottawa area. If I want to program by address, the default state is currently set to "QC" (Quebec) because the last address I programmed was up there. Various hotels in Montreal are in the database as well.

 

interesting question.. this shouldn't be an issue?

 

Did you program your canadian destinations in Canada or the U.S.A.? When I tried to program a Windsor ,Ca. address in the Detroit area I could not get the navigation system to insert any destination except a State.

 

I,over the lunch hour, have solved the puzzle. When you select "address", the screen takes you to ,select a state. You have an option to use the arrow in the upper right o fthe screen that says "state". Instead,use the keyboard to select a Canadian province, then fill in the city , street and number. You now have the route to wherever you wanted to go. After I jotted this note, but before I sent it, I tried the above routine, but I used the arrow. In the list of states were the Canadian provinces. It looks like you can select the Canadian province by either method.

 

I never had problem crossing between borders&states. You just have to change two digit state letters when u do cross-state driving