Prior to installing my aspec kit, I got a fresh front end paint job. To my dismay, I noticed some bubbling on the front bumper right above the aspec lip. I'm guessing the extreme heat combined with the aspec lip "smothering" the front end is to blame but I don't know for sure. Anyways, is it possible to get replacement clips for the "zip ties" that run through the drilled holes? I sure hope so, because I didn't see anyway for those to come off.

 

Subscribed because I have been wondering about this also.

I was planning on removing mine someday and redoing/reinforcing the 3m tape because there is a tiny part of mine that is now showing a small gap that I wanna fix sometime.

 

Yeah, same here. I only used the tape that was on the lip. Second time around I'm going to add a bunch more.

 

In for an answer, one side of my base lip has some gap that I would like to eliminate.

 

you can take the zip tie clips off, i used a needle nose and pushed the tabs on the clip in and pulled and it started to come off 1 by 1

 

Same gap on my 2004 A-Spec.

 

those clips are easily removable, definitely not permanent by any means, i've removed mine couple times