Emblem wrapped
#2
Looks great. How was it done? I was told the giant logo cannot be blocked due to sensors.
#3
took it to my tint spot. My guy tint the logo ring with a glossy vinyl wrap and the center Acura logo was tint with with a 20 percent widow tint . Sensors are working just fine. Haven’t had no issues
The following users liked this post:
Padre Dave (04-02-2023)
The following 2 users liked this post by specie:
D Rivera (01-16-2020),
Padre Dave (04-02-2023)
The following 2 users liked this post by D Rivera:
Padre Dave (04-02-2023),
subin (01-18-2020)
The following users liked this post:
Yotrek (01-21-2020)
#9
no he didn’t. He just put regular 20percent film in the center and cut it out. He did the same with the outside ring. U can take it to a regular tint place to get it done just make sure his good at it.
#11
I also did a gloss around the emblem and did a tint for the glass. I went with a 50%. I just wanted to get rid of the chrome but wanted the Acura to stay visible. Was also scared the sensors might not work if I went darker. But your 20% looks good! Here’s a pic of mine at 50%.
i also hyper dipped all the emblems Including the aspec sides and all rear emblems.
i also hyper dipped all the emblems Including the aspec sides and all rear emblems.
Last edited by dennisyah; 11-20-2020 at 01:54 PM.
#13
Plastidip
I am doing my emblems and I removed the RDX and SH-AWD badging. For those that are nervous doing it the paint is completely removable. Apply 5 or 6 coats for durability
Thread
Thread Starter
Forum
Replies
Last Post