2001roxyCL

ok im going to order some function and form type2 for my 2003 tl-s, and im still on the stock tires, well tomorrow im putting my rear camber kit on and right after the coilovers come in im gonna get new tires and im thinking about putting on some 225/45/17, and the front doesnt have a camber kit but im gonna get an alignment and get everything evened out, but im gonna put it pretty low like tucked a half in all around, do you guys think ill rub my wheel well, and if so, should i get the fenders rolled or pulled?

jjashaa

iTrader: (23)

i'd be more concerned about our neg camber on the front and the fender lining up front and also the jacking points..

don't think you need a roll or a pull with stock wheels that sit like.. an inch or so in.

. N B P .

Im on F2 Type 1's on my stockies and im tucked .5"-1".

I have an SPC rear camber and None in the front.

After getting it aligned, the front had -1.5

Like jjashaa mentioned. No need for Roll/Pull fenders.

jonmizu

roll and pull lol if you drive around long enough itll do that onthe front all on its own.... ahha every time you gotta pulll a u-turn make sure its mid afternoon at its hottest when your cars paint is ready to melt off lol and turn slowly

2001roxyCL

your camber was -1.5, how bad is that, idk the camber specification too well yet. and also could you send me some pics of how your car looks with that much tucked on the stockies

. N B P .

jjashaa

iTrader: (23)

being low..

being more worried about toe being off > being more worried about camber imo..

toe at neutral is all you gotta worry about.

SLushhYYY

iTrader: (8)

^^x2

I have -3.5 degrees camber in the rear but 0 toe and the tires are fine

thinhthan

im on tokico illuminas and teins springs with a 18x8 1/2 wide rims and the fender rolled it self after so many uturns and bumps lol

2001roxyCL

alright wats the widest tire you think we could fit on the stock type s wheels, i was gonna get either 225/45/17 or 225/50/17, but i wanted to see if i could put 235's?