I have a set of jdm inspire side markers off a 01 inspire in japan and would like to install them in the stock locations of the inspire/canadian aspec tl's to complete my exterior aspec conversion.

So i was hoping you jdm and aspec guys could measure the dimensions marked in the picture below (labled A,B,C,D). It would be extreamly helpful.

Thx in advance.
Michael

 

just buy jdm/a-spec fenders and wiring harness

 

Yea, because thats cost effective. I think measurements are cheaper

 

hahahahaha, good call Kris.

 

just make an estimate, doesnt have to be in an exact spot.......look for the beamer side marker DIY, and go off that.......

 

Michael,

I don't have an A-spec but if you have the picture ... and there is a 17" rim (ie reference length) ... you can figure everything out relative to the rim.

 

dude how are u getting ur hands on all the aspec parts? are u goin to be at the HSP meet next sat?

 

ohh yeah cuz he can just run right over the car store to grab a set of those

 

This is the pic of Mrmako's car which is 100% JDM (1999 Honda Saber). Hope you have better idea of where the side markers located.

 

cause most are JDM, and i spend too much time searching ebay, and in here for stuff that i can use for the aspec conversion.

Thx for the pic LacViet, it helps to ahve a differnet angle to help line everything up

 

i'm also thinking about picking up some JDM side markers, but can't find a-spec ones. the closest i found were accord JDM sidemarkers which actually looks like the one on the saber.