I just got all my new Inspire badging for my car from HeelToeAuto. Woot woot, shouts out to Marcus for the hookup, too.
But, I was wondering if anyone else has switched the engine cover emblem to an H, and if yous ran into the same problem lining up as I did.
I'll try and post pics when i get home today, but basically the Accords did not have horizontal lines going across the cover, and the H is a little offset from the original holes. It also looks a bit bigger than my old A. I think I'm going to end up redrilling the holes to center it, but I also may have to shave down the red lines to make it look uniformed.

If anyone else has already done this, hit me up. I'm wondering if there's a better way